Shini SG-23 Series, Руководство пользователя

Страница: 42 / 47

42(47)
6.4.4 Installation of Bearing Block and Bearing
Clean up the internal holes of bearing block. There should not be any scrap iron
or sundries. Turn the bearing block over to make its back side upward and then
slightly beat the oil seal in and spread lubricating grease onto it. After finishing
that, the bearing can be put into the bearing block smoothly by using the oil seal
to press it in or using the copper bar to beat it in.
Picture 6-12: Installation of bearing block and bearing
6.4.5 Installation of Bearing Cover Plate
Use blower gun to clean up the bearing roller and spread plenty of lubricating
grease on them. And then put on the bearing cover plate and tighten it up with
screws.
Picture 6-13: Installation of bearing cover plate
6.5
Installation of Bearing, Motor, Belt Plley and Belt
1) Install baffles at both of the right and left sides of blade rest.
2) Spread lubricating grease on bearing and bearing block and then put the
bearing into bearing block.
3) Use oil press to press the bearing to the bearing installation position on
rotation shaft.
4) After fixing the cutting chamber and base, put the blade rest into the cutting
chamber in the order from the left to the right and then tighten the bearing