12
OPERATION
FOR YOUR SAFETY:
If at any time you are unable to light burner
and smell gas,wait 5 minutes to allow gas
to dissipate before attempting to light heater.
If,after 1 minute, you are unable to light
burner, wait 5 minutes and allow flammable
vapors to dissipate before attempting to
light heater again.
WARNING
FOR YOUR SAFETY:
Do NOT touch or move heater for at least 45
minutes after use.
Allow emitter and dome to cool before
touching.
WARNING
Ignition Hole
Emitter Screen
Pu
sh
to
tu
rn
OFF
H
G
I
H
LO
W
T
O
LI
P
Pu
sh
to
tu
rn
OFF
H
G
I
H
LO
W
T
O
LI
P
Eletronic ignition
WARNING:
DO NOT attempt to operate heater until you have
read and understand all precautions.
Failure to do so can result in serious personal injury, death
or property damage.
Before Turning Gas Supply ON
Your heater was designed and approved for OUTDOOR USE ONLY. Do NOT
use it inside a building ,or any other enclosed area.
Make sure surrounding areas are free of combustible materials, gasoline
and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or servicing is replaced
and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use, and by a qualified
service person at least annually.
If relighting, always wait at least 5 minutes.
LIGHTING INSTRUCTIONS
Our heater is tested for quality assurance.
Ignition attempts should succeed 8 out of 10 attempts.
HEATER
HEATER
If you experience any ignition problem, turn off the heater and gas
supply, and consult "Troubleshooting" on page 19.
1)Turn the control knob to "OFF" position.
2)Fully open gas valve
3) Push in control knob and turn counter clockwise to "PILOT"
position, push in the ignition button and keep the button depressing untill
light the pilot.
4) Once the pilot is lit, continue to keep the control knob depressed for at least
30 seconds, After 30 seconds release control knob.
5) If pilot does not stay lit, repeat steps 3 and 4.
6) If pilot still does not stay lit, then:
a) Push in gas control knob and turn counter clockwise to "PILOT"
b) keep depressing the control knob, put long stem lighter into the
Ignition Hole on the emitter screen to light the pilot.
c) repeat step 4.
7) Push in and turn control knob counter clockwise to "HIGH" position,
If you want a lower temperature, push in the control knob and turn
clockwise to the "LOW" position.
