Shindaiwa SL433IDG, Руководство владельца и оператора

Страница: 11 / 28

8
5-4. Using the Lamp Fittings and Lamp Fittings Frame
(1) If changing the light projection direction in the
horizontal direction
If changing all lamp fittings at the same time
Hold a lamp fitting leg with one hand and loosen the
rotation handle.
Position the lamp fittings in the desired direction and
tighten the rotation handle.
If changing one lamp fitting
Support the lamp fitting leg with both hands and position in
the desired direction.
(It is not necessary to tighten the securing nut of the lamp
fitting leg.)
<Note>

Be careful that the lamp fitting cord is not pulled.

Perform the following procedures to tighten any securing
nut of the lamp fitting legs that becomes loose.

Tighten the nut (side near disc spring) by hand.

When the nut can no longer be turned by hand, use a
spanner (subtense of 27 mm) to further tighten by 90°.

With the spanner set so the nut (side near disc spring) is
secured, tighten the other nut (side opposite from the
disc spring) to secure the lamp fitting.
(2) If changing the light projection direction in the vertical direction
If changing all lamp fittings at the same time
<Note>
Adjust the left and right sides individually because they
move independently.
Hold a lamp fitting leg with one hand and loosen the
lamp fittings handle on the left (right) side.
Position the lamp fitting leg in the desired direction and
tighten the lamp fittings handle.
1
2
1
2
Lamp Fitting
Rotation
Handle
Tighten
Loosen
Lamp Fitting Leg
Lamp
Fitting
Turn
Loosen
Lamp Fittings Handle
Lamp
Fitting Leg
Securing
Nut of Lamp
Fitting Leg
(Double)
Lamp
Fitting Leg
Lamp
Fitting

Do not touch this tower light during operation if it or your body is wet.
WARNING: ELECTRIC SHOCK

To change the direction of a lamp fittings frame, be sure to always support
the lamp fittings frame or leg with one hand while loosening the rotation
handle.

Do not touch the lamps, lamp fittings or ballast when the lamps are lit up or
immediately after being turned off because they are extremely hot.

Wear work gloves if it is absolutely necessary to touch a lamp fitting when it
is hot.

Do not adopt an unnatural posture when adjusting the direction of a lamp
fitting.
CAUTION: INJURY/BURNS