Shindaiwa Shindaiwa SBA-TX24, Руководство владельца/оператора

Страница: 8 / 48

8
Installing a Blade
Checking Unit Condition
WARNING!
1. Make sure the switch is off and the
engine is stopped.
. Wear gloves to protect your hands.
3. Turn the unit over so that the blade
holder flange extending from the gear
case is facing up.
4. Using the small end of the plug
wrench,loosen the bolt(turn clockwise)
and remove the bolt,bolt guard and
holder.
5. Slide the safety clip as the illustration
shows.
Holder A
Gearcase
Blade
Safety Clip
Holder
Bolt Guard
Bolt
Safety Clip
Safety Clip
Blade
WARNING!
The blade must fit flat against
holder A. The blade’s mounting hole
must be centered over the raised boss
of the holder A.
NEVE� operate the unit with the cutting
attachment shield or other protective de-
vices (ignition switch, etc.) removed!
WARNING!
A cutting attachment shield or other
protective device is no guarantee of
protection against ricochet. You must
always guard against flying debris!
HEX WRENCH
PLUG
WRENCH
HEX
WRENCH
6. Fit the blade over the safety clip and
onto holder A. Then, slide the safety clip
back to the original position.
7. Put the holder and bolt guard back
and tighten the bolt finger tight only at
this time. Make sure the holder is flat
against the blade. The blade and the
recess in the holder must face the blade
and completely cover the safety clip.
8. �otate holder A until the hole in its skirt
aligns with the hole in the gear case.
Insert the hex wrench through both
holes (to prevent the shaft from turn-
ing).
9. Holding the hex wrench and the blade
with one hand, tighten the bolt (turn
counterclockwise) securely using the
small end of the plug wrench.
10. �emove the hex wrench.
WARNING!
Make sure the direction of the arrow
indicated on the blade corresponds
with the arrow indicated on the debris
shield.
WARNING!
Before operating, make sure the blade
is securely mounted. Turn the blade with
your hand slightly and make sure the
blade turns smoothly without wobbling.
Never operate this unit without
the safety clip in place.
Use only authorized Shindaiwa parts and
accessories with your Shindaiwa prod-
ucts. Do not make modifications to your
machine without the written approval of
Shindaiwa.
n
ALWAYS make sure the cutting attach-
ment is properly installed and firmly
tightened before operation.
n
NEVE� use a cracked or warped cutting at-
tachment: replace it with a serviceable one.
n
ALWAYS make sure the cutting attach-
ment fits properly into the appropriate
cutter holder. If a properly installed
attachment vibrates, replace the attach-
ment with a new one and recheck.
n
ALWAYS stop the engine immediately
and check for damage if you strike a for-
eign object or if the machine becomes
tangled. Do not operate with broken or
damaged equipment.
n
NEVE� allow the engine to run at high
�PM without a load. Doing so could
damage the engine.
n
NEVE� operate a machine with worn or
damaged fasteners or attachment holders.
NOTE:
A shoulder strap accessory is required for
use with Splitboom Attachment SBA-TX4. A
shoulder strap can increase operator comfort
during extended periods of operation.