Shindaiwa Shindaiwa SBA-TX24, Руководство владельца/оператора

Страница: 6 / 48

6
Assembling the Splitboom
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
Installing the Sub Guard
WARNING!
NEVER use this machine without sub
guard when using a trimmer head.
NOTE:
Make sure the edge of cutting attachment
shield is aligned with the groove of the sub
guard.
1. Install the sub guard.
See figure below.
Front Handle Assembly
Installing the Cutting
Attachment Shield
WARNING!
NEVER operate the Shindaiwa SBA-TX24
Splitboom Attachment without the cutting
attachment shield installed and tightly
secured!
CAUTION!
Make sure the clamp screw and retain-
ing nut are securely tightened before
tightening the four socket head cap
screws.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
Socket-
Head
Cap
Screw
Bracket
Outer
Tube
Cutting
Attachment
Shield
Shim
Cutting
Attachment
Mounting
Plate
Retaining
Nut
Shim
Hook
Receiver
Sub Guard
Hook
Cutting Attachment Shield
Socket-head
Capscrew
Outer Tube
Barrier
About 300mm
Nut
CAUTION!
Make sure the sub guard is completely
hooked at the hook receiver.
Installing the Front Handle to
the Outer Tube of the Shindaiwa
Multipurpose Engine
NOTE:
The underside of the handle mounting barrier
is recessed to receive the nuts.
Before assembling the handle, slide to
remove the front rubber grip from the
outer tube of the Shindaiwa Multipurpose
Engine.
1. Position the handle on the outer tube as
shown.
. Install the mounting barrier with the
socket-head screws and nuts. Tighten the
screws finger-tight ONLY at this time.
3. Locate the handle in the best position for
operator comfort (usually about 300mm
ahead of the throttle assembly).
4. Secure the handle by alternately tighten-
ing the four socket head screws in a
diagonal or “crisscross” fashion.
Handle