Shindaiwa Shindaiwa SBA-TX24, Руководство владельца/оператора

Страница: 10 / 48

10
Cutting With a Blade
Recommended Cutting Attachments
(1) After starting the engine, pull the
throttle lever gradually. The engine
speed increases and the blade will start
rotating.
() When the throttle lever is released, the
engine goes back to idle speed automati-
cally.
(3) Operate the machine at full throttle
while cutting. Best fuel efficiency is
obtained by releasing the throttle when
swinging back after cut.
(4) The blade rotates counterclockwise.
For best performance and to minimize
being stuck by debris, move the blade
from right to left while advancing on
your work.
WARNING!
Position the blade so cuts
are made between blade’s 8 o’clock
and 10 o’clock positions (as viewed
from above).DO NOT cut between the
11 o’clock and 5 o’clock positions.
WARNING!
“BLADE THRUST” is a sudden
sideway or backward motion of the
machine. Such motion may occur
when the blade jams or catches on
an object such as a sapling tree or
tree stump. BE CONSTANTLY ALERT
FOR BLADE THRUST AND GUARD
AGAINST ITS EFFECTS.
WARNING!
DO NOT use 2-tooth blades
with this machine.
CAUTION!
To prevent possible engine damage,
do not allow the machine to run at high
speeds without a load. Avoid operating
the engine at low speeds. Doing so can
lead to rapid clutch wear. In addition,
slow-speed operation tends to cause
grass and debris to wrap around the
cutting attachment.
Make sure to use the following recom-
mended Shindaiwa cutting attachments
with this machine.
Blades
PA�T NUMBE� 60903-98310
8-TOOTH BLADE
INNE� BO�E: 5.4mm
DIAMETE�: 55.0mm
THICKNESS: .0mm
PA�T NUMBE� 7430-914
3-TOOTH BLADE
INNE� BO�E: 5.4mm
DIAMETE�: 55.0mm
THICKNESS: .mm
PA�T NUMBE� 60903-9830
4-TOOTH BLADE
INNE� BO�E: 5.4mm
DIAMETE�: 55.0mm
THICKNESS: .0mm
Ten
O’Clock
Direction of
Rotation
OK TO CUT
DO NOT
CUT
Eight
O’Clock
WARNING!
Never strike or slam the
spinning blade against the wood.
WARNING!
When transporting, make
sure the engine is not running and the
blade is covered with the blade cover.
WARNING!
Never use this unit with an
unauthorized blade, doing so may
cause injury by creating an unbalanced
machine.
Recommended Trimmer Head
PA�T NUMBE� 67000-65010
TAP & FEED T�IMME� HEAD
BOLT DIAMETE�: 7mm
TH�EAD: LEFT PITCH: 1.00mm