Shindaiwa DGW340DM, Руководство владельца и оператора

Страница: 42 / 52

- 39 -
(9) Inspecting/Replacing Fuel/Cooling Water/Oil Hoses, Anti-Vibration Rubber
and Packing in Top and Bottom of Fuel Tank
Inspect Every 400 hours or 1 year
Replacement Every 2000 hours or 2 years
If rubber hoses (fuel, cooling water, oil, air, drain, etc.) are hardened or deteriorated,
please replace with a new rubber hose.
For rubber hose replacement, please contact the retail outlet where the equipment
was purchased.
Warning: Electric Shock/Injury
•
Do not operate the equipment if the equipment or your body is wet.
•
Always be sure to stop the engine and remove the starter key before performing
any equipment check or maintenance.
•
Do not operate the equipment with any doors or covers open. There is a danger of
hair, body parts and other items being caught up in moving parts such as cooling
fans and belts.
Warning: Fire
•
Always be sure to wipe up any spilled fuel or oil.
•
Spilled fuel and oil accumulates in the spill containment. Do not operate the
equipment with liquid accumulated in the spill containment.
•
Absolutely never use the equipment if there is a fuel, oil or cooling water leak, and
be sure to always repair the leak before using.
•
Absolutely never inspect or perform maintenance to the equipment near fire or
other open flame.
Warning: Fire/Burn
•
The engine, muffler and similar parts are extremely hot during operation and
immediately after stopping the equipment. Never touch hot parts.
•
Always be sure to stop the engine and allow it to cool before inspecting or
changing the engine oil. Opening the oil gauge or oil plug during operation will
result in hot oil spurting out.
Perform the following maintenance procedures if not using the equipment for two
months or more.
1) Remove the battery. (Refer to section "6-6. Battery Inspection".)
2) Change the engine oil. (Refer to section "11.(1) Changing the Engine Oil".)
3) Drain the fuel from the fuel tank and strainer.
(Refer to section "11.(4) Cleaning/Replacing the Fuel Strainer".)
4) Clean and inspect inside the spill containment.
(Refer to section "11.(8) Cleaning/Inspecting the Spill Containment".)
5) Remove the starter key and store in a secure location.
6) Clean all parts and store the equipment in an area with low humidity and little
dust with a cover or similar protection covering it.
<Note>
•
Recharge a removed battery approximately once every month.
12. Long-Term Storage