Shindaiwa DGW300MS/UK, Руководство оператора

Страница: 30 / 34

- 28 -
<Caution>
Change the seal, whenever changing coolant/water.
Seal Part No.
：
6C090-58961 (Kubota)
⑤
Replace all the coolant/water in the engine/radiator and sub tank.
⑥
Fill the coolant/water to the MAX level (to the upper edge of the inlet).
⑦
Reinstall the radiator cap.
⑧
Close the top plate.
<Caution>
After reinstalling the water drain plug tightly, keep the engine drive for a while to
check no water leakage and then stop the engine.
12. Long-Term Storage
Danger: Electric Shock
Before performing any equipment check or maintenance, stop the engine,
and remove the engine key. The person performing the maintenance must
always keep the key.
Caution: Injuries
Before performing any equipment check or maintenance, stop the engine, and
remove the engine key. The person performing the maintenance must always
keep the key.
Caution : Fire
・
・ ・
・
Burns
When checking engine, always stop the engine, and keep far away from fire.
Temperatures around the muffler and exhaust can get extremely high. Wait
until the engine cools down, before performing any inspection.
If the welder-generator is not to be used for more than two months, perform the
following maintenance and storage procedures.
①
Remove the battery. (Always remove negative [-] terminal first and always
reinstall positive [+] terminal first)
②
Change the engine oil.
③
Drain fuel from the fuel tank, the Fuel Strainer.
④
Clean all parts, cover the welder-generator, and keep it in the storage, away
from dust and humidity.
<Caution>
Store the battery in a well ventilated area away from risk of naked frames.
Recharge the removed battery once a month.
13. Troubleshooting
Danger: Electric Shock
Do not operate the equipment, if the equipment or you are wet.
Before performing any equipment check or maintenance, stop the engine.