Shindaiwa DG25MK, Сборка и инструкция по эксплуатации

Страница: 26 / 48

23
(2) Engine Oil Viscosity
Use a diesel engine oil with an appropriate viscosity corresponding to the ambient
temperature (refer to the table).

Relation of Viscosity/Temperature
Temp.
(°C)
(3) Engine Oil Replacement Amount
(Unit: L)
Total Lubrication Oil Amount
9.7 (0.3)
Value in parenthesis is the filter capacity.
8-2. Checking Coolant
CAUTION : BURNS

Do not open the radiator cap immediately after stopping the engine. Do so
will result in steam gushing out.

Hot steam gushes out from the coolant sub-tank if the generator overheats.
Do not touch the coolant subtank.
Check that the subtank coolant level is in between FULL and LOW. If the subtank
coolant is lower than the LOW level, add coolant to the subtank and radiator.
(1) Filling the Sub-Tank
Remove the sub-tank cap.
Fill the sub-tank with coolant until it reaches the
FULL line.
Re-attach the cap.
(2) Filling the Radiator
Remove the radiator plate.
Remove the radiator cap.
Fill with coolant through the filler neck until the
radiator is full.
Re-attach and tighten the radiator cap.
Attach the radiator plate.
< Note >

Be sure to only use long life coolant (LLC) for the
aluminum radiator. The coolant should be mixed with
good quality softened tap water, and contain
anti-freezing and anti-rust components.

The LLC mix ratio is 30% liquid and 70% water when shipped from the factory. (Isuzu
Genuine LLC: Besco LLC Super-Type E)

Be sure to use the same LLC in the sub-tank.

The mix ratio should be changed according to the ambient temperature but should
remain between 30 and 50%.

Do not increase the LLC mixture ratio unless necessary. Doing so could result in overheating
or another fault/malfunction.
5
4
3
2
1
3
2
1
SAE 10W-30
10W
SAE30
-30 -15 0 15 25 30 40
Filler Neck
給水口
Radiator
Plate
Radiator Cap
Sub-tank
LOW
FULL