Shindaiwa DG25MK, Сборка и инструкция по эксплуатации

Страница: 16 / 48

13
(3) Editor
This generator has with the Controller Editor function, which allows you to change
frequency, date and contrast of the controller.
Press the Stop Mode Button.
Press the Stop Mode Button and "
" button together to enter the editor
display.
Press the " " button or the " " button to select the main screen.

Main screens
○
Alt Config
Status Screen Contents
Config to Edit No use.
Default Config Change frequency.
(Refer to section"
5-4. Frequency change " )
○
Display
Status Screen Contents
Contrast
Set the Contrast.
The default contrast is 55%.
Date and Time
Set the Date and Time.
Press the " " or " " button to select the item you want to change.
Press the " " button.
Press the " " or " " button to change the item.
Press the " " button to confirm the changes.
To save the changes, press and hold the " " button.
Not to save the change, press and hold the Stop Mode Button.
5-2. Warning Indicators
WARNING : INJURY

Do not open the check door when the Power Switch is in the ON position. It
will cause injury by rotating parts such as cooling fans and fan belt.

Always turn the Power Switch to the OFF position and stop the engine, then
close and lock OPERATION PANEL DOOR before checking or maintaining
the engine or any equipment.
CAUTION: BURNS

Do not touch the engine and surrounding components immediately after
stopping the engine as they are still extremely hot.
This generator is equipped with the following warning indicators: Low Oill Pressure,
High Coolant Temperature, Air Filter Clogging, Overload Pre-Caution, Fail to Start,
Water In Fuel, Charge Alt Failure, Fuel Level Low. Turn the Power Switch to ON position
causes "Low Oill Pressure" and "High Coolant Temperature" warning indicator to
illuminate, and all indicator lights will go off as engine starts. An indicator illuminates if
malfunction/fault occurs during operation and the engine automatically stops depending
on the fault type. If the generator automatically stopped, check each illuminated warning
indicator at the time of engine stop, and inspect the failed component.
8
7
6
5
4
3
2
1