12
INSTALLATION
Installation of the hub to the frame
Installation of the hub to the frame
Rear side
The hub installation is an example. Also refer to the manual for the hub.
1
(A)
(B)
Mount the chain on the sprocket, and
then set the hub axle
(A)
into the
dropouts
(B)
.
(A)
Hub axle
(B)
Dropouts
2
(C)
(F)
(D)
(G)
(E)
Place the non-turn washers onto the
right side and left side of the hub axle.
At this time, turn the cassette joint
(E)
so that the projecting parts of the non-
turn washers fit into the grooves of
the dropouts
(D)
. If this is done, the
cassette joint can be installed so that it
is almost parallel to the chainstay
(F)
.
(C)
Non-turn washer (for left side)
(D)
Grooves of the dropouts
(E)
Cassette joint
(F)
Chainstay
(G)
Non-turn washer (for right side)
NOTE
When installing a part such as a mudguard
stay to the hub axle, install in the order
shown in the illustration below.
Non-turn
washer
Washer
Cap nut
Mudguard stay
Carrier stay
•
Use whichever non-turn washers match
the shape of the dropouts. Different non-
turn washers are used at the left and
right sides.
•
The projecting parts should be on the
dropouts side.
•
Install the non-turn washers so that the
projecting parts is securely in the
dropouts grooves on either side of the
hub axle.
Mark
ϴ
Dropouts
Non-turn washer
Mark/Color
Size
Right
Left
Standard
5R/Yellow
5L/Brown
ϴ
≤ 20°
7R/Black
7L/Gray
20° ≤
ϴ
≤ 38°
Reversed
6R/Silver
6L/White
ϴ
= 0°
Reversed
(full chain
case)
5R/Yellow
5L/Brown
ϴ
= 0°
Vertical
8R/Blue
8L/Green
ϴ
= 60° - 90°
Note: vertical: excluding the coaster specifications
To be continued on next page
