Shimadzu UW2200HV, Инструкция по эксплуатации

Страница: 82 / 130

66
14. Application Functions
Read Chapter 7 Before Use of
These Pages
3
Hook the hanging pan, and then immerse the
hanging pan in the tank filled with the liquid of
known specific gravity (or density).
4
From mass display, press the [UNIT] key sev-
eral times until T d (inverse triangle and “d”) is
displayed.
5
Press the [O/T] key.
6
Load the sample on the balance pan (or in the
hanging pan in air).
7
After the stability mark illuminates, press the
[CAL] key.
“dSP oL” may be displayed but this does not indi-
cate a malfunction.
8
Load the sample on the hanging pan immersed
in the liquid. The specific gravity (or density) of the
sample is displayed.
9
Repeat steps 5 through 8 for each additional
sample.
Notes
• Up to four decimal places are displayed for density or specific gravity.
Depending on the measurement conditions, not all digits are stable even
the balance is working normally.
When it is not possible to stabilize the display in all 4 decimal places,
you may change the minimum display by using the
[UNIT] key.
How to change the minimum display in density (specific gravity) display
When the result is displayed, press and keep holding down the [UNIT]
key for about three seconds.
This changes the minimum display to 10d (d: original minimum display).
Every time the same key operation is made, the minimum display
changes and cycles in the order of “1d
→
10d
→
100d
→
1000d
→
1d
→
”.
• When loading the sample on the pan in the liquid, ensure that the entire
sample is immersed in the liquid.
• The balance does not re-zero when the [O/T] key is pressed in this function.
• The dimensions of the below-weigh hook are shown in A-7.