Shimadzu OMRON CJ Series, Руководство по подключению к сети

Страница: 14 / 82

7
．
Serial Communications Connection Procedure
11
7. Serial Communications Connection Procedure
This section describes the procedures for connecting the Balance and the PLC via serial
communications. The procedures for setting up the Balance and the PLC in this guide are
based on the factory default settings.
For information on initialization, refer to Section 8. Initialization Method .
7.1. Work Flow
Take the following steps to connect the Balance and the PLC via serial communications and
send and receive a message.
7.2. SHIMADZU Balance Setup
Set up the SHIMADZU Balance.
↓
7.2.1 Parameter Settings
Set parameters for the Balance.
↓
7.3. PLC Setup
Set up the PLC.
↓
7.3.1. Hardware Settings
Set the hardware switches on the Serial
Communications Unit and connect the cables.
↓
7.3.2. Opening the Project File and
Going Online with the PLC
Start CX-Programmer, open the project file and go
online with the PLC.
↓
7.3.3. Creating an I/O Table
Create an I/O table for the PLC.
↓
7.3.4. Parameter Settings
Set parameters for the Serial Communications
Unit.
↓
7.3.5. Transferring the Project Data
Transfer the project data to the PLC.
↓
7.3.6. Starting CX-Protocol and
Opening the Project File
Start CX-Protocol and open the project file.
↓
7.3.7 Going Online and Transferring
the Protocol Data
Place CX-Protocol online and transfer the protocol
data to the Serial Communications Unit.
↓