Shimadzu AGS-100NX, Инструкция по эксплуатации

Страница: 110 / 154

Chapter 5 Performing Tensile Tests
5-4
5.3 Setting Crosshead Stroke Limits
To prevent the crosshead (or attached load cells or jigs) from colliding with anything, secure
upper and lower limit collars at respective crosshead upper and lower movement limits.
For tensile tests, use the tensile stroke length as a reference to keep any extra cushion to a
minimum at both upper and lower limits.
The crosshead upper and lower limits expected during a test must be set to proper values.
If setting these limits is difficult, determine the setting range so that the gap between the
crosshead top jig and the crossyoke and the gap between the crosshead bottom jig and
the table jig are 25 mm or more.
After securing upper and lower limit collars, hold the collars and move the limit bar up and
down to confirm that there is no slippage.
Stroke Origin Point
Gauge Length
(distance between grips)
MAX
Tensile Stroke
α
α