-
7 -
4. Screen instruction
4-1. Power on and initial screen display
After turning on power, the display shows each power on initial screen for approx. 1.5 seconds, then moves into the basic screen of the mode 0 screen
group.
4-2. Screen change
(1) Screen change from mode 0 group to mode 1 group
•
Keep pressing the
key for three (3) seconds on basic screen of the mode 0 screen group to change screen into direct call screen of
mode 1 screen group. Keep pressing the
key for three (3) seconds on direct call screen of mode 1 screen group to change
screen into basic screen of the mode 0 screen group.
NOTE: In the above, the mark
indicates that the key above the mark is presed. The same applies hereinafter.
(2) Screen change from mode 0 group to mode 2 screen
•
Keep pressing
key for five (5) seconds on basic screen of the mode 0 screen group to change the screen into mode 2 screen. Keep
pressing
key for five (5) seconds on the mode 2 screen to change screen into basic screen of the mode 0 scrren group.
(3) Screen change within mode 0 screen group
•
By pressing the
key, the screen changes.
•
Without alarm option and with ON-OFF action, only basic screen is displayed and no screen change is performed by pressing the
key.
Series type (
,
,
,
)
Input type (
: Thermocouple,
: R. T. D.,
: Voltage(mV),
: Voltage(V),
: Contact(mA))
Displays output screen
Output type (
: Contact,
: SSR drive voltage,
: Current,
: Voltage)
Lower limit of the selected measuring range
Higher limit of the selected measuring range
Mode0 screen group basic screen
Measured value (PV)
Set value (SV)
Power on
initial
screen
Turning on power
0-0 basic screen
1-0 direct call screen
key
3 seconds
0-0 basic screen
2-0 Function selecting screen
5 seconds
key
0-0 basic screen
0-1 AT action control screen
0-2 higher limit alarm set screen
key
key