Shibuya R1511, Инструкция оператора, Страница: 6 / 32

5
SAFETY
[9]
Before operation, do ensure that the Drill Stand is fixed firmly to the surface of drilling object.
[10]
Never use this machine without the Portable Residual Current Device (PRCD), which is equipped in the
electric cable. And inspect it periodically to confirm that it works properly.
[11]
Before starting drilling, make sure that there is no live electric cable in the drilling object that the Core-Bit will
cut through.
[12]
Do not allow other persons to use this machine, unless they have read and understand this manual.
[13]
Unintentional start of the Drill Motor is quite dangerous. When the Drill Motor is not in use with the drilling
operation, do ensure that the switch is in the “OFF” position, and that the plug is disconnected from the power
source outlet.
[14]
If the main power supply gets power failure during operation, turn off the switch immediately in order to avoid
the unintentional start of the Drill Motor.
[15]
When drilling at high level, keep proper footings and balance at all times. Maintain a firm grip, in order not to
drop the machine. Use extra care when you are on ladders, roofs, scaffolds, …etc.
[16]
When drilling through floors, the core will be likely to fall down from inside of the Core-Bit. Under these
circumstances, provide proper protections for people and property below the coring area. For example,
fencing around the particular area down floor, making the place “KEEP OFF” …etc.
[17] Never yank the cord to disconnect it from the socket. Keep the cord away from heat, oil and sharp edges.
[18] Plug is essential for safety. Never connect directly to distribution board without using a plug for fixed
installation.
[19]
This machine must not be used for drilling upwards for electrical reasons. When drilling horizontally on the
wall, water collection device must be used.
[20]
All the services, with the exception of maintenance written in this manual, must be carried out by authorized
service center.
[21]
Always compare the voltage value on your Core Drill with your proper supply source. The power supply
source should not vary more than 10% from the voltage figure shown on the nameplate.
[22] Do not operate the machine alone. Make sure you can contact someone in the event of accident.
[23]
Do not allow anyone near the machine when starting or operating. Keep bystanders away from the machine
and cable.
[24]
Use common sense and plan your work to avoid injuries. Your own safety as well as the safety of your fellow
worker depends on your carefulness and good judgment during the operation.
[25]
Avoid body contact with earthed or grounded surfaces (e.g. pipes, radiators, ranges, refrigerators).
[26]
The use of any accessory or attachment other than one recommended in this instruction manual may present
a risk of personal injury.