Shibuya R1511, Инструкция оператора, Страница: 17 / 32

16
② ①
ALLEN KEY 6mm HANDLE
ＡＬＬＥＮ KEY 4mm
MAINTENANCE
9.0 MAINTENANCE
WARNING!!
Always disconnect machines from power supply before starting any maintenance, cleaning, and inspection.
9.1 ADJUSTMENT OF CARRIAGE BLOCK
The Carriage Block must be adjusted when there
is a play or when the Feed Handle does not
revolve smoothly. Adjustment procedure is as
follows.
1. Tighten/Loosen
○
2 Hex. Socket Screw
w/Resin pad and
○
1 Hex. Socket Screw
by using Allen Keys (6mm and 4mm),
while checking a play of the Carriage
Block by rotating the Feed Handle to
ensure the smooth revolution
9.2
RE
PL
ACEMENT OF CONSUMPTION PARTS
The followings are consumption parts. When you find wear of these parts, replace them with new spare parts.
R1511/R1521 Drill Motor:
Carbon Brushes, O-Rings, and Seal Rings
Armature, and Field Coil (to be replaced by authorized dealers)
TS-132/TS-162 Carriage Block:
Roller (F), Roller Shaft (F), Roller Shaft (R), Sliding Plate
9.3 REPLACEMENT OF ROLLERS INSIDE CARRIAGE BLOCK
If the Carriage Block still have a play and it does not move smoothly even after the adjustment, Rollers inside the
Carriage Block have to be replaced.
Please refer to “11.0 DAILY INSPECTION” for a proper period of the replacement of Rollers.
Proper way of the replacement of Rollers is explained as follows;
Replacement of Roller (F)
1)
Disassemble the Drill Motor from the Carriage Block by loosing 3 ea. Hex Socket Bolt M8x30 by inserting a
T-Shape Long Allen Key from the service holes on the Back Cover of the Carriage Block.
2) Loosen
○
1 Hex. Socket Screw (M6x12) and
○
2 Hex. Socket Screw (M6x30).
3) Take out
○
3 Roller Shaft (F) and
○
4 Roller, and replace them with new ones.
4) Tighten
○
1 &
○
2 Hex. Socket Screws firmly.
CAUTION!
If Hex. Socket Screw is tightened too hard, the Carriage Block cannot be moved accurately. Pay attention
not to tighten the screw too strongly.
①
②
③
④