Shibuya Hoppmann L500A V2, Инструкция по установке и обслуживанию

Страница: 23 / 92

22 23
Label Style Stripped out form only, with a minimum spacing of 0.125"
(3 mm). Remove all die cut waste (skeleton). Label back-
ing must have a release agent such as silicon. Label must
free peel when pulled around a standard peeler plate with
a minimum label gap of 0.125" (3 mm).
Accuracy (A) Linear position of label relative to web or backing must
be centered.
(B) Die cutting and edge slitting must be controlled to avoid
cutting or nicking of the web backing. Failure to regu-
late this will result in web failure and label dispensing
problems.
(C) Web must be a minimum of 0.25" (6 mm) wider than
label to be dispensed.
Roll Put-Up Maximum O.D. of roll is 14" (356mm) with a core I.D. of
3" (76 mm). Label orientation is based on equipment and
product orientation. The labels must be wound to the outside
of the roll.
Splices Splices should be avoided as much as possible, but when
splices are needed, please use "Angle" style, flush to
the edge and on both sides of backing using 1" (25 mm)
cellophane splice tape. Replace the label in the spliced
area.
Label Tolerance A label tolerance of +0.05" (0.02mm) can be maintained
provided that:
(A) Labels are manufactured to the right label specifica -
tion with no die cuts into liner.
(B) Lateral position of labels are within 0.0025" (0.06
mm) on the x and y axes.
do not use foil or metal labels with capacitance
sensor. they will damage the label sensor.
Label Threading
Only use labels that can be stripped out. More information on label and
web specifications are available in Table 4‑1.
Before installing a label roll please read Table 4-1 to insure the selec-
tion of proper label stock.
Applicator Setup
Table 4-1. Label &
Web Specifications
Label & Web Specifications
4