Shibaura CM314, Руководство оператора

Страница: 62 / 74

•
Special diesel fuel system flushing oils are
available from most oil companies. If special
flushing oil is not readily obtainable, mix 0.5
liters of SAE 10 non-detergent engine oil with
10 liters or No. 2 diesel fuel.
•
Drain the fuel tank and pour 7 liters of the
special flushing oil (or lubricating mixture) in
the fuel tank.
•
Run the engine for 10 minutes to ensure
complete distribution of the special oil
through the injection pump and fuel injectors.
There is no need to remove the injector
nozzles.
•
Fill the fuel tank with No. 1 diesel fuel.
I MPORTANT: Do no use No. 2 diesel fuel for
winter storage because of wax separation and
setting at low temperature.
6. Open the drain valve of the radiator and the
engine block. Flush the system, close the
drain valve, and fill with a 50/50 solution of
permanent antifreeze and clear water.
7. Remove the battery and clean it thoroughly.
Be sure that it is fully charged, and that the
electrolyte is at the proper level. Place it in
storage in a cool, dry place above freezing
temperature. The battery should be charged
periodically during storage.
8. Place blocking under the front and rear axles
to remove the weight from the tires.
A Commercial Mower that has been placed in
storage should be completely serviced in the
following manner before using.
1. Inflate the tires to the recommended
pressures, and remove the blocking.
2. Check the oil level in the engine crankcase,
the common sump (for the hydraulic lift,
transmission, front axle and power steering),
and rear axle.
3. Install a fully charged battery.
4. Check the cooling system for proper level of
50/50 solution of antifreeze and clear water.
5. Start the engine and allow it to idle a few
minutes. Be sure the engine is receiving
lubrication and that each control is
functioning correctly.
6. Drive the unit without a load and check to be
sure its operating satisfactorily.
CAUTION: TO AVOID PERSONAL INJURY:
•
TO REDUCE FIRE HAZARDS, ALLOW
THE ENGINE AND EXHAUST SYSTEM TO
COOL BEFORE STORING THE VEHICLE
IN AN ENCLOSED SPACE OR NEAR
COMBUSTIBLE MATERIALS.
•
DO NOT CLEAN THE MACHINE WITH
ENGINE RUNNING.
•
WHEN STORING, REMOVE THE KEY
FROM THE KEY SWITCH TO AVOID
UNAUTHORISED PERSONS FROM
OPERATING THE MACHENE AND
GETTING INJURED.
3-27
LUBRICATION AND MAINTENANCE