Shibaura CM314, Руководство оператора

Страница: 51 / 74

3-16
COOLING SYSTEM
The CM mower engine must operate at the
correct temperature to obtain maximum
efficiency and service life. This is dependent on
the cooling system.
Always fill the system with a 50/50 solution of
permanent antifreeze and clear water.
Checking the Coolant Level
NOTE: Check the coolant level daily or after
every 10 hours of operation. The engine
should be cold when coolant level is
checked.
Open the hood, and check the coolant recovery
reservoir located next to the battery. The fluid
should be between the low and the full marks
on the reservoir.
If the coolant recovery reservoir is empty,
remove the radiator cap
A
and add a 50/50
solution of water and antifreeze until the radiator
is full. Then add the water antifreeze solution to
the coolant recovery reservoir until it is to the full
level.
WARNING: THE COOLING SYSTEM OPE-
RATES UNDER PRESSURE CONTROLLED
BY THE RADIATOR CAP. IT IS DANGEROUS
TO REMOVE THE CAP WHILE THE SYSTEM
IS HOT. ALWAYS COVER THE CAP WITH A
THICK CLOTH AND TURN IT SLOWLY
COUNTERCLOCKWISE TO THE FIRST
STOP. ALLOW ALL PRESSURE TO ESCAPE
BEFORE REMOVING THE CAP COMPLET-
LEY.
If the coolant level is below the low mark on the
reservoir, add a 50/50 solution of water and
antifreeze to the coolant recovery reservoir
bringing the level to the full mark.
Be sure that the radiator fins are clear of chaff
and dirt to allow free air monement.
LUBRICATION AND MAINTENANCE
GENERAL MAINTENANCE
COOLANT RESERVOIR
A
COOLANT SYSTEM
1. Radiator Cap