Shibaura CM314, Руководство оператора

Страница: 55 / 74

FUSE BLOCK
The fuse block, is located on the left side of the
mower compartment. Always replace blown
fuses with the size specified for that circuit.
FUSIBLE LINK
A fusible link wire
A
is used to protect the
mower’s entire electrical system. If too much
amperage passes through this wire it will melt
down so that it will no longer allow current to
pass (similar to the way a fuse works). The
fusible link wire is a red wire that goes from the
starter terminal to a connector that links into the
main wiring harness.
To replace the fusible link wire:
1. Disconnect the negative battery cable from
the battery.
2. Unplug the connector linking the wire to the
main wiring harness.
3. Remove the old fusible link wire from the
starter terminal.
4. Replace the old fusible link wire with a new
one-first attaching to starter terminal, and
then connecting into the main wire harness.
IMPORTANT: Always replace the fusible link wire
with the appropriate fusible link wire for this
Mower (part No. 385603370).
3-20
LUBRICATION AND MAINTENANCE
Fuse size Circuit protected
1 10 amp Temperature gauge, fuel gauge
Fuel pump, monitor lamp,
Alarm buzzer & relay
2 10 amp Head lamp, meter back light,
stop solenoid, safety SW,
starter, cruise control (opt.)
3 10 amp Spare
4 20amp Cellular-phone socket
5 20amp Auxiliary P.T.O
Wark lamp (opt.)
Back buzzer (opt.)
6 20amp Spare
A B C D E F
FUSE BLOCK
A
ELECTRICAL SYSTEM PROTECTION
1. Fusible Link