Shibaura CM314, Руководство оператора

Страница: 26 / 74

2. Connect one end of the jumper cable to the
battery positive (+) terminal and the other to
the auxiliary battery positive (+) terminal.
Connect one end of the other cable first to
the auxiliary battery (-) negative terminal, and
the other end to the (-) negative terminal.
Follow the starting procedures above after
the jumper cables are connected as
instructed.
Idle the engine and turn on all electrical
equipment, then disconnect the cables in
reverse order of the connecting procedure
above. This will help protect the alternator from
damage due to extreme load changes.
WARNING: BATTERIES CONTAIN SULFU-
RIC ACID AND PRODUCE EXPLOSIVE
GASES. FOLLOW THE INSTRUCTIONS
BELOW TO PREVENT PERSONAL INJURY.
•
Wear eye and skin protection.
•
Keep sparks and flame away.
•
Always have adequate ventilation while
charging or using the battery.
•
If ice is present or the battery is cracked, DO
NOT ATTEMPT TO“JUMP START”vehicle.
•
Follow the battery manufacturer’s instructions
which are shown on the battery.
•
Bring helper vehicle with a battery of the
same voltage as disabled machine within
easy cable reach.“THE VEHICLES MUST
NOT TOUGH”.
ENGINE WARM-UP
In cold weather, run the engine at half throttle for
a few minutes to allow engine oil and
transmission oil to warm-up.
WARNING: ALWAYS APPLY THE PARKING
BRAKE, WHEN LEAVING THE SEAT.
STOPPING THE ENGINE
Stopping the engine should be done according
to the following procedures;
1. Push the throttle lever fully rearward.
2. Release the HST foot pedals.
3. Apply the parking brake.
4. Place the range selector and lift control levers
in the“N”position.
5. Turn the key start switch to the“OFF”position.
6. Remove the key.
IMPORTANT: Failure to turn the key start switch
to the“OFF position, after the engine stops,
will allow the warning lights to remain on,
causing the battery to discharge.
IMPORTANT: Do not stop the engine
immediately after hard or extended operation.
Keep the engine running at slow idle for about 2
minutes to allow engine to cool down.
2-14
OPERATION