Sherpa 901233, Инструкции по безопасности и руководство по эксплуатации

Страница: 14 / 20

14
Servicing
Servicing
It is recommended that before using the heater after a period of 3 months or before using
the heater:
• Check the condition of the gas cylinder .
• Check the hose assembly for any wear or damage . If the hose and regulator assembly is
damaged or more than 1 .5 years old replace with an approved hose and regulator .
• Frequently checking the tubing or the flexible hose at least once per month and each
time the cylinder is changed . If it shows signs of cracking, splitting or other deterioration
it should be exchanged for a new hose of the same length and off the equivalent quality .
• The tubing or the flexible hose must be change within the recommended time frame.
• Check for leaks .
Solving Common Problems
The 3 most common problems associated with any gas heater are gas leaks, wrong gas
pressure and dirt .
DO NOT USE YOUR HEATER WITHOUT CHECKING FOR LEAKS . Leaks can occur during
shipment and installation. A simple solution of soap and water dabbed on the fittings will
bubble if a gas leak is present . (page 3)
WRONG GAS PRESSURE . Too much gas pressure may severely damage your heater . Too
little gas pressure and your heater will not burn correctly .
DUST AND DIRT . This heater requires some cleaning . If the pilot light will not stay lit, your
heater is probably in need of cleaning and servicing . Replacement of thermocouple or
pilot assembly is generally not needed . Refer to CLEANING AND MAINTENANCE in this
manual .
Warning
Servicing should be carried out by a qualified
gas engineer only .