15
The control panel lights up, the fan is
running, no strikes arc welder
1. Check the correct terminals and the electrical conductivity of the electrode wire and the mass
2. Check the connection of TIG torch to the device, pay attention to whether the socket pins are not
broken or jam.
3. Unscrew the TIG torch handle and check that the switch in the handle is OK
The control panel lights up, the fan is
running, the OC LED is on display
message "E00"
1. The device is overheated. Wait a few minutes. After the indicator goes out to
continue welding.
Unsatisfactory quality of the weld MMA
electrode sticks to the work piece
1. Check the polarity of the welding wire
2. Check that the electrode is not wet. Replace the electrode.
3. The welder is supplied from the generator or by a long extension cord diameter is too small
cable. Connect directly to the mains
Unsatisfactory quality of the weld
TIG welding
1. Replace consumables. Change the tungsten electrode or the gas cylinder for higher quality
materials
2. Check that the shielding gas flowing at the proper intensity
3. Check the gas hose, improve the connection hose with quick connectors, and status
4. Check regulator przybutlowy.
List of error codes:
E00
Overheating or incorrect parameters welding current
E01
Invalid parameters mains
E02
Internal driver error
E03
Incorrect parameters of the power supply and internal controller error
12. OPERATION MANUAL
Operation of the device DIGITIG 200AC / DC MULTIPRO should take place in an atmosphere free of corrosive components and dusty. Do not place the
device in dusty, near the working grinders, etc. Dust and pollution control boards metallic filings, wires and connections inside the unit may cause an
electrical short, and consequently damage to the welding machine.
Avoid use in environments with high humidity, especially in situations of occurrence of dew on the metal parts.
If there is dew on the metal parts, for example. After entering the cold equipment into a warm room, wait until the dew disappears. It is recommended
that in the event of welding operation outdoor place it under a roof to protect against adverse weather conditions.
Device DIGITIG 200AC / DC MULTIPRO should be operated under the following conditions:
-
changes in the effective value of the supply voltage is not greater than 10%
-
ambient temperature of from -10 ° C to + 40 ° C
-
Atmospheric pressure 860 to 1060 hPa
-
relative humidity of the atmosphere is not more than 80%
-
height above sea level to 1000m
You k with consumable parts TIG torch T 26:
You k with consumable parts TIG torch T 26:
You k with consumable parts TIG torch T 26:
You k with consumable parts TIG torch T 26:
lp
Name
1 tungsten electrode
1 tungsten electrode
2 Compression sleeve T-26
2 Compression sleeve T-26
3 The connector current T-26
3 The connector current T-26
4 Gas nozzle T-26
4 Gas nozzle T-26
For a full list of consumables and spare parts is available on the website and in the company www.tecweld.pl TECWELD. There is a
possibility of direct purchase of these parts.
