11
ARC FORCE
ARC FORCE allows the arc. Shortening the length of the arc is accompanied by an increase in the welding current, which results in stabilizing the arc.
Decreasing the value will give a soft arc and a smaller depth of penetration, while increasing the value results in deeper penetration and the possibility of
short-arc welding. At a set high value ARC FORCE function you can be welded while maintaining the minimum arc length and a high speed electrode
melting range: 0 - 100A
9.2 TIG
Selection button welding method (C), choose HF TIG welding or TIG Lift. Button to choose the type of current (F) to select current (DC) or alternating
(AC). Switch pulse (B) on or off pulse. Press (G) to select the waveform. Set the welding parameters:
Time the gas pre ( ) -
the time from pressing the button on the handle of the gun and opening the gas valve until the arc ignition. It should normally be no
Time the gas pre ( ) -
the time from pressing the button on the handle of the gun and opening the gas valve until the arc ignition. It should normally be no
Time the gas pre ( ) -
the time from pressing the button on the handle of the gun and opening the gas valve until the arc ignition. It should normally be no
Time the gas pre ( ) -
the time from pressing the button on the handle of the gun and opening the gas valve until the arc ignition. It should normally be no
longer than 0.5 seconds, to provide shielding gas to the outlet nozzle of the burner in order to shield the welding start site and the tungsten electrode. In
case of a longer supply pipe gas cylinder przedwypływu time should be longer.
Range: 0.1 - 15s.
Initial current (
And Start) - current appearing in the circuit by pressing the button in the handle grip. The higher initial current, the easier ignite the arc.
Initial current (
And Start) - current appearing in the circuit by pressing the button in the handle grip. The higher initial current, the easier ignite the arc.
However, when welding thin sheet too high value of the initial current can lead to a sheet of burning. In some modes, the welding current does not grow
in order to heat the work piece. Range: 5 - 200A.
Welding current (
Current) Adjustment
Welding current (
Current) Adjustment
range: 5 - 200A.
Pulse width (
PULSE Duty) - pulse duration, allows you to adjust the depth of penetration. The increase in width increase the depth of penetration,
Pulse width (
PULSE Duty) - pulse duration, allows you to adjust the depth of penetration. The increase in width increase the depth of penetration,
reduction reduces the amount of heat entering the material, reducing the risk of burnout of thinner plates and smaller components.
Lower values of the pulse width must be used for higher currents. The greater the pulse width must be applied to small currents, a width of more than
50% should be used for currents lower than 100A.
Range: 10 - 90%.
Current base (
Current Base) - responsible for maintaining current welding process, the lower the value of the current pulse. It helps control the
Current base (
Current Base) - responsible for maintaining current welding process, the lower the value of the current pulse. It helps control the
quantity of heat input to the material. Base current control is only possible when welding with pulsing range: 10 - 90% of the welding current.
