In the case of numbers associated with units which use non integer numbers such
as ppm(v), pressing the key repeatedly beyond the fifth character makes the
decimal point (“.”) flash and therefore active.
For example in order to change the alarm level from 0.843 to 8.43 ppm(v).
Use the key to position the dp in the required position. Pressing the key at
any point confirms the numerical value. °C and °F are fixed to 1 decimal place.
The Password used within the AcuTrak is made of four integers and
does not use the dp.
To leave the numerical part of this routine without saving, simply press
the key.
8.1 Hot Keys
Panel Function
The ‘Units’ and ‘Alarms’ Hot Keys can be restricted using the ‘Panel’ function in the
Setup Menu so that the Units and Alarms settings may only be inspected rather
than adjusted using the Hot Keys. If the user tries to set an Alarm when the ‘Panel’
function is set of ‘OFF’ the user will set the message
rOnlY
to indicate that the
parameter is “Read Only”
While
PAnEL
is displayed, press the key to enter the subroutine. The main
display will now display
On
or
OFF
. Use the key to select
On
or
OFF
.
Press the key to confirm selection.
ESC
Note:
Note:
26
