8
9
Bottom of Remote
Power ON/OFF
Oscillation ON/OFF
UV Bulb On/OFF
Timer
Fan Speed
Oscillation
UV Light
Power
UV
Speed Settings
Timer Settings
Using the Remote Control
Battery Installation
One CR2025 3V battery is included with the remote control. To change the battery,
remove the battery door at the back of the remote by squeezing the tab and pulling
the door away from the back of the remote. Please insert the battery into the remote
with the positive side up as shown on the drawer.
NOTE: Always keep the battery and remote control out of the reach of children.
BATTERY NOTE
• If the unit is not going to be used for a long period of time, remove batteries to
prevent damage due to possible battery leakage.
• Clean the battery contacts and also those of the device prior to battery
installation.
• Remove used batteries promptly.
• Dispose of properly in accordance with all state, province, and country
regulations.
• Do not dispose of batteries in fire. Batteries may explode or leak.
4. Place the tabs at the bottom of
the grill plate into the base of the
unit. Gently push the grill plate
back into place until you hear
a click sound indicating that the grill
is firmly latched.
Connect the power cord into a
standard AC outlet.
NOTE: Unit will not operate unless filters and grill are properly installed.
1. On/Off and Speed Settings
• To turn the air cleaner on, press the ON/OFF
button on the control panel.
When the air cleaner is on, the LED light in the ON/OFF button on the control panel
will be lit and the air cleaner will start to operate on LOW speed.
• Once the air cleaner is ON, press the + button to increase the fan speed to the
MED. settings. Press the + again to increase the fan speed to HIGH setting. To
decrease the fan speed, press the – button until your desired setting is reached.
The fan speed setting is indicated by LED ring around the fan icon.
• To turn the air cleaner OFF, simply press the ON/OFF
button on the
control panel.
2. Timer
There are four possible timer settings: 2 (two) hours, 4 (four) hours, 8 (eight) hours,
and 12 (twelve) hours. To activate the timer press the + button on the control panel
under the TIMER LED screen. Each time the + button is pressed, it will display the
successive settings. To return to a setting already passed, press the – button. Once a
timer setting has been selected, it will remain displayed on the LED screen.
3. Oscillation
To activate the oscillation, press the
button. To stop oscillation, press the button a
second time.
4. UV-C Bulb
To activate the UV-C bulb, press the UV-C button on the control panel. To turn the UV
bulb off, press the button a second time.
Fig. 4
