SPEAKERS
1 Align the channels on the speakers with the guides on the
main unit.
2 Slide the speakers down into position until the tops of the
speakers and main unit are flush.
3 Slide the release lever as shown in the illustration to lock
the speaker.
4 Pull the speaker leads out enough to reach the SPEAKERS
terminals. Connect the leads with the stripe to the (-) and the
other leads to the ( + ) terminals. Fit the speaker leads into the
channels in the speakers and main unit.
• Removing the speakers
1 Disconnect the leads from the SPEAKERS terminals.
2 Slide the release lever as shown in the illustration to un-
lock the speaker, and then pull the speakers up and off the main
unit.
3 Pull the speaker leads out as far as necessary and connect
them to the SPEAKERS terminals.
SETTING THE CLOCK
Turn the POWER switch OFF/SLEEP before connecting the speakers.
Caution
• Maximum speaker input is 100 W (PMPO) or 26 W (RMS).
The speakers could be damaged if used with an amplifier producing greater than 100 W (PMPO) or 26 W (RMS).
• Do not short circuit the amplifier speaker outputs or speaker inputs as this could damage the amplifier and/or speakers.
• Speakers with less than 8 ohms impedance should not be used as the amplifier could be damaged.
1 While pressing the CLOCK button with a pencil tip or simi-
lar object, press the HOUR button to set the hour. Next press
the MINUTE button to set the minutes.
2 Press the CLOCK button again to start the clock from the
" 0 0 " second.
HOUR and MINUTE buttons
Press once to advance one digit. Hold depressed for more than
two seconds to advance continuously.
• Mounting the speakers
