Sharp WF-939ZP, Руководство по эксплуатации

Страница: 8 / 17

CASSETTE OPERATION
• Be sure to use quality tapes for best results.
• The use of tapes longer than C-90 (90 minutes) is not
recommended.
• Before loading tape into cassette compartment, tighten
slack tape with pen or pencil.
• Cassettes have removable tabs which allow recording to
take place. Removing tab on top left protects side facing up
from erasure. Cover tab holes with adhesive tape to erase or
record again.
• TAPE 1: Playback only.
TAPE 2: Playback or recording.
(1) If PLAY is pressed and STOP/EJECT is then pressed while
there is no power (AC cord is not connected, no batteries in-
stalled) and the power is then turned on and FAST WIND is
pressed, the tape will momentarily advance at normal play-
back speed with audio output before fast-forwarding begins.
(2) When battery power drops, the tape may not advance even
if RECORD or PLAY is pressed. Also, the cassette compart-
ment may not open when STOP/EJECT is pressed. Replace
the batteries or use the AC cord.
TAPE 1 and TAPE 2 functions differ. Refer to the table below for proper use and differentia-
tion of tape functions.
FUNCTION
Auto-reverse from A-B
Single side play
Switching sides A-B
APLD/APPS/APSS
FAST WIND
Recording
Full Auto-Stop
Dubbing
Continuous Play
TAPE 1
Sides A-B are played continuously until
STOP/EJECT is pressed when the REV MODE
switch is at
Press the button to play sides A and В and then
s t o p .
Possible when the REV MODE switch is at
Playback can be switched to either direction.
• When is pressed for one-cycle auto reverse,
playback will not proceed from side В to A.
Possible
Possible
Impossible
TAPE 2
Sides A-B are played continuously until
STOP/EJECT is pressed when the REV MODE
switch is at
Possible when the REV MODE switch is at
Either side can be selected during playback;
switching from В to A during recording is not
possible.
Impossible
Possible
Recording and playback are possible.
All buttons are reset at the end of the tape in all modes except continuous auto reverse.
Possible from TAPE 1 to TAPE 2 (High/Normal).
Combined auto-reverse is possible from TAPE 1 to TAPE 2.
The following may occur due to the use of
soft-touch controls. Note that these are not
malfunctions.