
4
VL-Z700S-T
VL-Z800S-S/E-S/E-T/Z900H-S
VL-Z950S-S/E-A/E-S/E-T/E-W
3. DISASSEMBLY OF THE SET
3-1. Procedure for disassembling the cabinet
Note:
Before removing the cabinet, turn OFF the power and make sure that the battery is not connected.
1.
· Remove the screw ((s) XiPSF14P06000).
· Open the LCD panel 90 degrees and remove the two screws ((x) LX-
HZ0050TAFN).
· Remove the two screws ((c) XiPSN17P04000) and remove the
camera front cover by pulling it frontward.
2.
· Disconnect the connector of the camera front cover.
· Disconnect the two LCD tilt FPCs of the LCD panel.
· Remove the two screws ((r) XiPSN20P08000) and remove the LCD panel.
· Remove the screw ((p) LX-HZ0063TAFN) and screw ((q) XiPSN17P06000)
that hold the camera L cabinet, open the terminal cover and remove the three
screws ((b) XiPSN17P03000).
3.
· Disconnect the hot shoe FPC of the hot shoe and remove the camera L cabinet.
· Remove the screw ((c) XiPSN17P04000) and remove the camera bottom
cover.
· Disconnect the INNER LED FPC or strobe FPC, remove the two screws ((a)
XiPSN17P02000) and remove the INNER LED Unit or strobe unit.
å
Precautions in servicing the strobe unit
Once put in the card mode, the main condenser of the strobe unit stays still
electrically charged. If touching the strobe unit or its nearby parts, you may
get an electric shock.
To avoid this, connect a 7 k
Ω
resistor (300-V withstand voltage) across the
main condenser for about 10 seconds. The condenser will be discharged.
s
c
x
LCD panel
Camera front cover
x
c
r
r
p
b
b
q
Camera L cabinet
Connector
LCD tilt FPC
Camera front cover
Terminal cover
Camera front cover
LCD panel
b
VL-Z700/Z800
VL-Z900/Z950
VL-Z700/Z800
VL-Z900/Z950
a
a
Camera
bottom cover
Camera L cabinet
Strobe FPC
INNER LED
FPC
Strobe unit
INNER LED unit
Hot shoe FPC
c
a
a