Sharp UX-P100, Руководство по обслуживанию

Страница: 8 / 92

1 – 6
UX-P100U
UX-P200U
4
Attach the Paper Tray and Paper Tray Extension.
Note: The Paper Tray Extension has a top side and a bottom side. If you
cannot insert the tabs into the holes, turn the support over.
Insert
horizontally
and rotate up.
4. Loading Paperfor Printing
You can load letter or legal size paper in the Paper Tray. The maximum
number of sheets is as follows:
Letter size: 50 sheets (20-lb. paper at room temperature; maximum
stack height of 5 mm)
Legal size: 5 sheets
1
Fan the paper, and then tap the edge against a flat surface to even
the stack.
2
Insert the stack of paper into the tray, PRINT SIDE DOWN.
• If paper remains in the tray, take it out and combine it into a single
stack with the new paper.
• Be sure to load the paper so that printing takes place on the print
side of the paper. Printing on the reverse side may result in poor
print quality.
The stack
should not
be higher
than this line.
Make sure the stack
edges are even.
Note: Do not use paper that has already been printed on, or paper that
is curled.
Note: If at any time the display shows
the alternating messages at right, check
the printing paper. If the tray is empty,
add paper. If these is paper in the tray,
take it out and then reinsert it.
When you are finished, press .
START/MEMORY
ADD PAPER &
PRESS START KEY
↑
↑
3
Setting the paper size.
The fax has been set at the factory to scale received faxes to letter
size paper. If you loaded legal paper, you must change the paper
size setting to LEGAL.
FUNCTION
1. Press once and twice.
2. Press once and twice.
3. Press once.
4. Select the paper size:
LETTER: LEGAL:
5. Press to return to the date and time display.
1
2
STOP
OPTION SETTING
Display:
PAPER SIZE SET
1=LETTER, 2=LEGAL
COPY CUT-OFF
The display briefly shows
your selection, then:
4
Print contrast setting.
You fax has been set at the factory to print at normal contrast. If
desired, you can change the print contrast setting to LIGHT.
FUNCTION
1. Press once and twice.
2. Press once and 3 times.
3. Press once.
4. Select the print contrast:
NORMAL: LIGHT:
5. Press to return to the date and time display.
1
2
STOP
OPTION SETTING
Display:
PAPER CONTRAST
1: NORMAL
PAPER SIZE SET
The display briefly shows
your selection, then: