Sharp SJ-FS810V-WH, Руководство по обслуживанию, Страница: 45 / 48

SJFS810VWH
45
9) Bundle harness by insulating (vinyl) tape, L-band c and fix at I-grill.
*Fix L-band c same as below picture but don't roll.
*Don't pull harness of Ice cube heater by more than 2 kgf.
(1)Bundle protect tube covering Thermistor and Ice cube heater by fix at I-grill.
*Cover edge of protect tube (Ice cube tray at side) with Ice heater cover t.
(Don't pull harness strongly)
*Line edge surfaces of protect tubes and bind at left side of marking of Ice cube heater as below picture.
(about 55mm between edge surface of protect tube and center of L-band c)
(2)Roll up the insulating (vinyl) tape twice and more on the thermistor harness and Ice cube heater harness.
Bundle harnesses of Ice maker ass'y , Thermistor and Ice cube heater and fix them at I-grill.
*Don't be too loose harnesses of Thermistor and Ice cube heater.
(3)Three harness is bundled in a nylon band.
claw Connector housing
JST:YLP-06V
Soket contact
JST:SYF-01T-P0.5A
hole No.6
hole No.3
opposite direction
claw
claw
into No.3
into No.6
L-band c
L-band c
heater’s marking
protect tube must be coverd with Ice heater cover
I-grill
55±5
(2) (1)
Nylon band
25±5mm
Nylon band
20±5mm 100±5mm
Insulating (vinyl) tape
[Color : black ,
width : 38mm or 50mm ,
length : 100mm]
Ice cube heater harness
Thermistor harness
L-band C
Insulating (vinyl) tape
(3)
10) Fix Harness cover at I-grill by tapping screw.
*Don't nip harness of Ice maker ass'y.
Screw
Harness cover