Sharp SJ-FS810V-WH, Руководство по обслуживанию, Страница: 44 / 48

SJFS810VWH
44
6) Put harness of Ice maker T-T ass'y through hole A and hole B (in front and back side of I-grill).
*hole A(front side) : for harness of Ice maker ass'y
hole B(back side) : for harness of Thermistor ahd heater
*protect tube edge (Ice cube tray at side) is always coverd with Ice heater cover t.
(don't pull harness strongly)
*Check whether red tape wraps harness of heater.
7) Set Ice maker T-T ass'y to I-grill.
*Axis of Ice cube tray at hock hole C, reiease stopper (front side) and put legs of Ice maker ass'y under the stopper.
*Put harness of Ice maker ass'y through hold D along front of Ice maker ass'y.
*Check fixing stopper after put Ice maker T-T ass'y.
*Check head of Ice senser is hole E.
• There is more than 2.5mm clearance between head of Ice senser and hole E.
I-grill
Ice maker T-T ass’y
harness(heater)
harness(heater)
Ice maker ass’y harness
hole A (front side hole)
hole B (back side hole)
8) Connect socket contact of Thermistor and Connector housing of Ice maker ass'y.
*Don't mistake putting socket contact and attend direction claw of socket contact.
• Connector hole : No.3 (claw direction is same as Housing one)
• Connector hole : No.6 (claw direction is opposite of Housing one)
*Check certainly putting socket contact in Connector housing.
• Don't remove when you pull by 9.8N(1.0kgf).
• Don't force to put in.
harness of
Ice maker ass’y
Legs of Ice
maker ass’y
axis of Ice cube tray at,
hole C (I-grill)
hole E (to release Ice senser)
hole D
more than 2.5mm
back side
front side
Stopper
clearance
clearance