Sharp SF-2530, Руководство по эксплуатации

Страница: 58 / 92

56
ADF (SF-A17)/RADF (SF-A56)
OPTIONAL EQUIPMENT
ADF (SF-A17)/RADF (SF-A56)
Stream feeding mode
The stream feeding mode allows easy operation of continuous
copying from the ADF or RADF. If the stream feeding mode has
been enabled using user program No. 5, the original feed
indicator will continue to blink for approximately 5 seconds after
feeding of all originals is completed. While this indicator is
blinking, any new originals placed in the document feeder tray
will be fed and copied automatically. If the stream feeding mode
has been disabled, the START key must be pressed each time
the originals are set even immediately after completion of a
copy run from the ADF or RADF. The default setting of the
stream feeding mode is “OFF”. See page 34, USER
PROGRAMS.
1-sided copies of 1-sided originals
1 Adjust the original guides to the size of the originals and
set the originals face up in the document feeder tray.
●
The ORIGINAL SIZE indicator for the detected original size will
light up, and the paper tray with the corresponding paper size
will be automatically selected.
●
The auto paper select function can be disabled using user
program No. 8. If this function has been disabled, use the TRAY
SELECT key to select the desired paper tray. See page 34,
USER PROGRAMS.
●
To copy onto a different size paper, use the TRAY SELECT key
to make the selection.
● If an original is left on the document glass, the original reminder
indicator will blink. Remove the original from the document glass
in this case.
Using the ADF or RADF
●
Special originals such as transparency film and
tracing paper should not be fed from the ADF and
RADF, but should be placed on the document glass.
● Duplex copying will not work when a non-standard
sized paper is used. (Duplex copying can be per-
formed only when an optional duplex module is
installed.)
●
Different size originals with the same width can be
placed in the document feeder tray and automati-
cally copied onto copy paper of their respective
sizes.
The automatic copy ratio selection will not function
in this case.
●
Image loss (max. 5/32" (4 mm)) can occur at the
leading and trailing edges of the copies.
●
Before loading originals into the document feeder
tray, be sure to remove any staples or paper clips
from them. The ADF or RADF can handle a maxi-
mum of 50 originals.
●
Damaged or crumpled originals may misfeed in the
ADF and RADF. It is recommended that these be
copied from the document glass and the copies be
used as original documents.
●
When feeding originals which have closely spaced
binding holes punched along an edge, place the
originals so that the punched edge is positioned to
the right or along the side guides.