Sharp Plasmacluster KC-6400E, Руководство по эксплуатации

Страница: 23 / 100

ENGLISH
DEUTSCH
TROUBLESHOOTING
Before calling for repair, please review the list below, since the problem may not be a unit malfunction.
SYMPTOM
REMEDY (not a malfunction)
Odours and smoke are not
removed.
• Clean or replace the filters if they appear to be heavily soiled.
(Refer to E-17,E-20)
The CLEAN-SIGN Light
illuminates green even when the
air is impure.
• The air could be impure at the time the unit was plugged in.
(Refer to E-8)
Pull out the plug from the electrical outlet, and insert the plug
one minute later.
The CLEAN-SIGN Light
illuminates orange or red even
when the air is clean.
• The sensitivity of the sensors become unstable when the
opening of the odour sensor or dust sensor is dirty or is clogged.
Clean the dust around the sensor opening using a vacuum
cleaner. (Refer to E-16)
A clicking or ticking sound is
heard from the unit. • Clicking sound or ticking sound is emitted when the unit is
generating ions.
The discharged air has an
aroma or odour.
• Check to see if the filters are heavily soiled.
Replace the filters.
• Plasmacluster Air Purifiers emit small traces of ozone which
may produce an odour. These ozone emissions are well below
safety levels.
The unit does not operate when
cigarette smoke is in the air.
• Is the unit installed in a location that is difficult for the sensor to
detect cigarette smoke?
• Are the dust or odour sensor openings blocked or clogged?
(In this case, clean the openings.) (Refer to E-16)
(Care Cycle : MIST Filter : 1 month)
The MIST Filter Indicator Light
remains activated even after
replacing filter.
• After replacing filters, connect the power cord to an outlet and
press the Mist Filter Reset Button. (Refer to E-19)
The Plasmacluster Indicator
Light or the CLEAN-SIGN Light
will not activate.
• Check to see if the Lights OFF Mode selected. If so, then
press the Plasmacluster ON/OFF Button for 3 seconds to
activate the indicator lights.
(Refer to E-15)
Plasmacluster Indicator Light
repeat colour cycles between
light and shade.
• The ION SHOWER operation is working.
• Check to see if the Mist Tray and Tank are installed correctly.
• Check the Mist Filter. Replace the filter when it is heavily soiled.
(Refer to E-19,20)
• Please check if the impurities adhered to the surface of the
Float.
Clean the Mist Tray.
Check to see if the Main Unit is put on a inclined surface.
The CLEAN-SIGN LIGHT switches
frequently. • The CLEAN-SIGN Light will automatically switches the colours
when detected by dust and odour sensors.
E-21
*
The Mist Filter Indicator Light does
not turn on even water is in.
When the water of the tank does
not decrease or the decrease of
the water is slow.
Only KC-6500E is equipped with the Dust sensor.