2008/June/16
CD-DK890N_US
40
CD-DK890N
Advanced Features
Enhancing your
s
y
s
tem (continued)
Auto
p
ower on function:
When you press any of the following buttons, the unit turns on.
AUDIO IN button (main unit and remote control): The unit turns on
and the “AUDIO IN” function is activated.
/ button on the main unit: The unit turns on and playback of
the last function starts (CD, TAPE, TUNER, AUDIO IN).
To record on a ta
p
e from VCR, etc.
Head
p
hone
s
Before plugging in or unplugging the headphones, reduce the
volume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and
impedance between 16 and 50 ohms. The recommended
impedance is 32 ohms.
Plugging in the headphones disconnects the speakers
automatically. Adjust the volume using the VOLUME control.
Trou
b
le
s
hooting chart
Many potential problems can be resolved by the owner without
calling a service technician.
If something is wrong with this product, check the following before
calling your authorized SHARP dealer or service center.
General
CD
p
layer
1
In
s
ert a ca
ss
ette in the TAPE 2 ca
ss
ette com
p
artment.
2
Pre
ss
the AUDIO IN
b
utton.
3
Pre
ss
the
b
utton.
4
Pre
ss
the / (TAPE )
b
utton.
5
Start the
s
y
s
tem, VCR, etc.
TIMER
CD
4
3
1
5
4
5
3
2
1
PHONE
S
RECORD/PLAYBACK
PLAYBACK
(PLAY & STOP)
2
AUDIO
IN
Sym
p
tom
Po
ss
i
b
le cau
s
e
The clock is not set to the
correct time.
Did a power failure occur? Reset
the clock. (Refer to page 15.)
When a button is pressed,
the unit does not respond.
Set the unit to the power stand-
by mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 42.)
No sound is heard.
Is the volume level set to “0”?
Are the headphones connected?
Are the speaker wires
disconnected?
Sym
p
tom
Po
ss
i
b
le cau
s
e
Playback does not start.
Is the disc loaded upside down?
Playback stops in the
middle or is not performed
properly.
Does the disc satisfy the
standards?
Is the disc distorted or
scratched?
Playback sounds are
skipped, or stopped in the
middle of a track.
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?
