Sharp AX-1100, Руководство по обслуживанию

Страница: 13 / 56

AX1100(R)
5 – 4
3. Drain Water Function
Perform the Drain Water function at least once a day after cooking with steam. It takes up to 7 minutes.
Drain Water function is very useful to prevent scale build up and the use of stale water. It causes evaporation of the internal steam system.
PROCEDURE
1. Remove the water tank. Ensure that no food is in the oven.
Press INFO/KITCHEN TIMER once to select In F1.
2. Press START/AUTO MINUTE . In F1 will fl ash on and off in the display during the Drain Water function.
3. When the drain function has ended and the oven is cool, wipe oven cavity. Wait a few minutes, then empty the drip tray.
NOTE: 1) The water tank must be removed before starting this procedure.
2) If Drain Water Function is set, Energy Save Mode will be cancelled temporary.
4. Descale Function
White or gray grains, also called scale, may form in the water circuit inside the oven during steam generation, which could cause the oven to malfunc-
tion.
When “DESCALE (flashing)” is shown in the display, be sure to carry out Descale function immediately. It takes about 1 hour (for descaling using citric
acid is for about 30min. The rinse time is approx. 30min.).
PROCEDURE
1. Pure citric acid, available at some drugstores, or bottled 100% lemon juice with no pulp are used for descaling. Choose one and prepare the des-
caling solution.
To use pure citric acid, dissolve 1 tablespoon of pure citric acid crystals in 500ml of water in a non-porous container. Stir well and pour into
the water tank to the MAX mark.
To use 100% bottled lemon juice, check that there is absolutely no pulp in it. If there is pulp or you are not sure, strain through a fine strainer. Mea-
sure 70ml of the strained lemon juice and add it to 500ml of water. Stir well and pour into the water tank to the MAX mark.
Place the water tank in the oven correctly and push firmly into place.
2. Press INFO/KITCHEN TIMER twice to select In F2.
3. Place the glass tray in lower position (position 2) closely to attach to the back side of the oven wall.
4. Do not place any food in the oven. Close the door firmly.
Press START/AUTO MINUTE to begin descaling.
5. When the oven has stopped and is cool, remove water tank, empty, rinse and refill with room temperature water suitable for drinking (filtered) to
the MAX mark. Replace the water tank.
Empty the drip tray and replace it. Remove glass tray, empty, rinse and dry. Follow step 3 to replace glass tray. Close the door firmly.
Press START/AUTO MINUTE . Rinsing will start.
6. When rinsing has ended and the oven is cool, remove water tank and empty. Remove glass tray and empty. Wipe oven cavity to dry. Wait a few
minutes and then empty the drip tray.
NOTE: If Descale Function is set, Energy Save Mode will be cancelled temporary.