25
LC-26GA5E
LC-32GA5E
LC-26GA6E/LC-26BV6E
LC-32GA6E/LC-32BV6E
LC-37GA6E
Use the up / down arrows to select a term in the
menu.
Confi rm the selection with
OK.
Use the left / right arrows to change between pa-
rameters.
Use the up / down arrows to change values.
Press END button to return to the previous menu.
NVM Menu
To change NVM values.
ADDR:
NVM address.
VAL:
NVM
Value.
SAVE:
Save NVM changes.
HDMI NVM WP:
Unprotect the EDID, that contains the recognizable formats of screen for HDMI.
ERASE:
If you select YES and Turn OFF-ON the TV by main switch, the data of NVM will be recorded
to the default values .
In
ADDR
option of this menu, by using the colour buttons of R/C is possible to pass directly to A, B, C or D param-
eter.
Note: DO NOT
change any NVM data, unless you have been advised to do by a Sharp representative. If data is
incorrectly changed, serious damage may occur to the receiver.
DEVICE:
To select QS peripherals ICs. ( 0:LCD Controller / 1:QS Driver / 2: Extended Digital Analog Converter /
3: EEprom Microcontroller / 4: Reserved)
ADDR:
Address of register.
DATA:
Read mode: Display data after executing “SEND” / Write mode: Select data to write.
R/W:
Select Read or Write. ON: write OFF: read.
SEND:
Send data to QS.
Use the up / down arrows to select a term in the
menu.
Confi rm the selection with
OK.
Use the up / down arrows to change values.
Use the left / right arrows to change between pa-
rameters.
IC Cont Menu (NOT OPERATIVE)
Send specifi c data to the QS board.
Press END button to return to the previous menu.
IC CONT
DEVICE 0
ADDR
000
DATA
00
R/W
OFF/ON
SEND
GA6 VX.XX
ExpX
PxW Exp X.X LCD VXX
MENU NVM
ADDR:
_ _ _ _
VAL
:
_ _
SAVE
HDMI NVM WP
YES
ERASE
NO
A B C D E F
GA6 VX.XX
ExpX
PxW Exp X.X LCD VXX
M T
FREQ:
Change between 50/60Hz and PC.
CLR MODE:
When press OK key send the value to monitor microcontroller.
PATTERN1:
Choose pattern to adjust QS.
PATTERN2:
Choose pattern to adjust QS.
COMBIAS:
Specifi c adjustment for QS. COMMON BIAS adjusting value is displayed.
IC CONT:
See the next OSD.
SOFT VER.:
Software version of QS IC. Display the version of monitor microcontroller.
COMBIAS Adjustment
Select COMBIAS and press the “OK” button so that the fl icker screen will appear.
Adjust the fl icker on the screen to minimum with up / down buttons on the remote control. At this time, press the “OK”
key to complete the adjustment.
www.ma163.com 电子技术资料网