17
LC-26GA5E
LC-32GA5E
LC-26GA6E/LC-26BV6E
LC-32GA6E/LC-32BV6E
LC-37GA6E
How to enter the Service Mode
Use the up/down arrows imprinted on the ring of the
R/C to select a line/term in the menu.
Confi rm the selection with
OK
this will take you to
the next menu.
Press END button to exit of Service Menu.
Video Menu
If you select the VIDEO option the next On Screen Display appear:
Use the up/down arrows to select a term in the
menu.
Confi rm the selection with
OK
this will take you to
the next menu.
Pressing END button the OSD returns to the
previous menu.
Use the up / down arrows to select a term in the
menu.
Confi rm the selection with
OK.
COLOUR OSC
is adjusting automatically when
is selected.
VCT Menu
To adjust parameters of VCT IC.
Pressing END button the OSD returns to the
previous menu.
AIS:
Autoinstallation.
The Service Mode is provided to enable the engineer to correctly set up the receiver.
Note that the value of these adjustments may vary from one receiver to another.
Before enter the Service Mode , make factory settings and put the TV in “Dynamic Mode” (Image Mode).
To enter the Service Mode, carry out the following procedure.
1. Connect a test pattern to the antenna terminal.
2. Tune the receiver to this signal.
3. Turn the receiver off using the mains switch.
4. Press volume down and channel up buttons on the top of the receiver at the same time.
5. Keeping these buttons pressed, turn the mains on.
6. Keep pressed the volume down and channel up buttons until the Service Mode On Screen Display (OSD) ap-
pears:
SHARP SERVICE
VIDEO
AUDIO
PW
LCD CONT
NVM
OTHERS
AIS
OFF
HOTEL MODE
VIDEO
VCT
FRC
FINE ADJ
SUBADJ
GA6 VX.XX
ExpX
PxW Exp X.X LCD VXX
VCT
PATTERN
OSD
IF
COLOUR
OSC
OFF
WHITE BALANCE
RGB WHITE BALANCE
W/B PATTERN
OFF
GA6 VX.XX
ExpX
PxW Exp X.X LCD VXX
GA6 VX.XX
ExpX
PxW Exp X.X LCD VXX
www.ma163.com 电子技术资料网