63
8
MISFEED REMOVAL
When the misfeed (
) indicator blinks or
blinks in the display, the unit will
stop because of a misfeed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
) indicator will blink, while the misfeed (
) indicator
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF"
(p.67).
1
Open the multi-bypass tray,
and then open the side
cover.
2
Check the misfeed location. Remove the misfed paper
following the instructions for each location in the illustration
below. If the misfeed (
) indicator blinks, proceed to "A:
Misfeed in the paper feed area" (p.64).
If paper is misfed here, proceed to "
A:
Misfeed in the paper feed area
". (p.64)
If paper is misfed here, proceed to "
B:
Misfeed in the fusing area
". (p.65)
If the misfed paper is seen from
this side, proceed to "
C: Misfeed
in the transport area
". (p.66)
If paper is misfed here, proceed
to "
D: Misfeed in the lower
paper feed area
". (p.66)
AL-2030_2040CS.book 63 ページ ２００７年４月６日 金曜日 午前１１時３２分
