EN 2
ENGLISH
DEUTSCH
ESP
AÑOL
IT
ALIANO
FRANÇAIS
Р
УССКИЙ
POLSKI
1
2
R
L
3
CAUTION
• Since this product is heavy, be sure that
it is unpacked and carried by at least
two people. Carrying it by yourself may
lead to injury.
• Use a commercially available screwdriver
and tighten the screws securely.
• When using an electric screwdriver, set the
tightening torque to 2.0 N·m (20 kgf·cm).
Assembly of the Stand Unit
1
Place the TOP-C packaging material
on a level surface as shown in the
illustration below.
2
Install the stand mounting brackets
into the grooves of the packaging
material.
• Pay attention to their right/left sides
and orientation.
3
Remove the front cover of the stand
base and install it according to the
shape of the packaging material.
• Remove 2 screws on the stand base.
• Slide the front cover along the shape
of the stand base.
Attaching the Stand
4
Fix the stand base and stand
mounting brackets using the 8 screws
(large) for stand assembly. Then,
attach the front cover.
• Slide the front cover along the shape
of the stand base.
• Slide and attach the front cover in the
arrow direction in such way that the
"projections on the rear surface of the
front cover" are put into the "tabs on
the rear cover".
• Fix the front cover using 2 screws that
have been removed in Step 3 above.
• Do not use an electric screwdriver for
these screws. Tighten them slowly with
your hand.
5
Prepare a table and lay the display
down on it.
• To prevent damage to the LCD panel
and LED part, place a soft cloth such
as a blanket on the table, etc. and lay
the display down on it.
• Do not remove the protective sheet of
the main body until the completion of
the installation.
6
Insert the stand and fix it using 4
mounting screws (small) for the stand.
The attaching of the stand is now
complete.
When standing the TV main body
upright
• Be careful not to press the TV screen too
hard with fi ngers.
When removing the stand
• When moving this Monitor to another
location, remove the stand using the
reverse order of the attaching procedures
in "Attaching the Stand". Be careful of the
projection on the LED part of the front side
of the display.
• To prevent damage to the LCD panel
and LED part, place a soft cloth such as
a blanket on a table, etc. and place this
Monitor on it.
4
Gap between
the cover and
metal: About
1.6mm
6