USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR.
This remote is designed to operate different types of VCRs. You must first program the remote to match the remote system of your
VCR. (refer to page 18 for pre-codes)
1.
Turn ON your VCR.
2.
Aim the remote control at the front of your VCR.
3.
Press and release the ANALOG mode button.
4.
Push ÒSELECTÓ key and ÒCH
H
Ó key at the same time, then release both buttons, and within 10 seconds after releasing these
buttons, enter the 2 digit code number as shown on page 31.
5.
Aim the remote at the VCR and press the POWER button. The remote will turn off your VCR when the correct two digit preset code
is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off, try a different two digit
preset code.
6.
The remote will now control your VCR.
NOTES:
1.
If your VCR cannot be operated after performing the
above procedures, your VCRÕs code has not been
precoded into the remote.
2.
In the unlikely event that your VCR cannot be operated
after performing the above procedures, please consult
your VCR operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
a
PRECODED VCR Buttons
These buttons transmit the chosen precoded VCR codes.
For some VCRs, you must press the RECORD button twice
to record a program.
b
EXCLUSIVE TV Buttons
These buttons are for operating the TV.
b
b
a
MY VCR CODE IS:
NOTE:
Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.
17
Содержание 50NP4
