sharkclean .com/AI RobotS E
sharkclean .com/AI RobotS E
LIVING WITH YOUR ROBOT
!
CAN’T CONNECT TO WI-FI?
Restart your phone
• Turn off phone, wait a few minutes, then turn it back on
and connect to Wi-Fi.
Reboot your robot
• Make sure the power switch on the back of the base is
in the ON position.
• Take robot off base and press and hold down the
CLEAN button on the robot for 12 seconds. Turn your
robot back on by placing it on the base.
Reboot your router
• Unplug the router power cable for 30 seconds, then
plug it back in. Allow several minutes for your router to
reboot completely.
• Then follow the steps outlined in the SharkClean™ app
Wi-Fi setup instructions.
Your robot can easily climb over most thresholds,
but if one is higher than 0.75”, set up a no-go zone in
the app to block it off.
DOORWAYS AND THRESHOLDS
AVOID MOVING THE ROBOT OR BASE
While your robot is cleaning,
DO NOT
pick it up and
move it, or move the charging base—this will impact
the robot’s ability to map your home.
CHECK BASE FILL LEVEL
The dust bin is designed to hold up to 60 days of
debris. During initial use, you may have to empty it more
frequently while the robot finds more debris than usual.
Check the fill level regularly to know when to empty.
Questions?
For how-to videos, FAQs, troubleshooting, and tips & tricks, call 1-888-228-5531 for robot support or visit:
sharkclean.com/AIRobotSE
PREP YOUR HOME
NOTE:
Scheduling is one of many features that can only be done in the app.
Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
are regularly maintained.
!
OBSTRUCTIONS
Clear cords and objects
smaller than 3.5" in height
from floors and open interior
doors to ensure a complete
map of your home.
SCHEDULING
Schedule whole-home
vacuuming runs with the app.
THRESHOLDS
Your robot can easily climb
over most thresholds, but if
one is 0.75" or higher, set up
a no-go zone in the app to
block it off.
AVOID MOVING THE
ROBOT & BASE
While your robot is cleaning,
do not pick it up and move
it, or move the charging
base—this will impact the
robot’s navigation and ability
to return to the base when
cleaning is complete.
STAIRS
Your robot’s cliff sensors
will prevent it from falling
off ledges. For the cliff
sensors to work properly in
any mode, all runners, rugs,
or carpets must be at least
8 inches from any stairs, or
must extend over the edge of
the stairs.
!
