SGM G-PROFILE, Руководство пользователя

Страница: 15 / 72

15
Control panel operations
You can configure individual fixture settings, read out data and view error messages in the graphic display. When the fixture
is powered on, it boots and resets, then displays the DMX start address and any status messages.
Using the control panel
• Click the arrow buttons to scroll up and down menus.
• Click the OK button to enter a menu or make a selection.
• Press the ESC button to step backwards through the menus.
DMX start address
The DMX start address is the first channel used to receive instructions from the controller. For independent control, each

fixture must be assigned its own control channels. If you give two fixtures the same address, they will behave identically.

Address sharing can be useful for diagnostic purposes and symmetrical control.
Select DMX address using the arrow buttons.
Selecting module (G-Profile or G-Spot)
If you replace the fixture’s module in order to switch from a G-Profile to a G-Spot or vice-versa, you need to change the fixture’s
software settings.
In the Control Menu, go to ‘Settings → Service Menu → Fixture Type” and select the fixture you are currently using.
NOTE: To access “Service Menu → Fixture Type”, you need to type in the value ‘0110’ under ‘Settings → Service Pin”.

See “Control panel menus” on page 22 for more details.
ESC.
OK
Manual_G_Profile_EN_170x113,3.book Page 15 Wednesday, December 9, 2015 10:17 AM