SGM G-1 BEAM, Руководство пользователя

Страница: 11 / 32

11
G-1 Beam battery (optional - POI n/a)
Installing or replacing batteries
To install or replace the batteries (one, two or three batteries) in the G-1 Beam base unit, follow the procedures outlined below.
• Disconnect the fixture from power (if applicable).
• Remove the head from the base and place the base in a stable position before proceeding. See “Removing the head from
the base” on page 17.
1. Remove the screw (TX25) next to the True1 power input.
2. Remove four screws (TX25) under the base and remove the bottom bracket part.
3. Remove seven screws (TX25) under the base.
WARNING! Risk of electric shock.
Step 1
Step 2 Step 3
4. Carefully flip the top part of the base in the direction of the arrow. Take into consideration the cables connected from the top
part to the bottom part of the base. Ensure the gasket do not get damaged.
Figure 9: Installing G-1 Beam batteries I
Figure 10: Installing G-1 Beam batteries II
Figure 11: Installing G-1 Beam batteries III