9
4 Performing a correlation measurement
4
Performing a correlation measurement
4.1
Entering pipe data
Before starting a measurement, it is required to enter the pipe
data.
Select option pipe data using
z
the Arrow keys and confirm
your selection with the Enter
key.Then, enter the number of
pipe sections.
Depending on the type of ap
-
z
plication, select One, Two or
Three pipe sections with the
arrow keys. Confirm your se
-
lection with the Enter key.
Enter the pipe length. Use
z
the left or right arrow key to
change between the displayed
digits.
You can use the Up/Down
z
arrow keys to increase or
reduce the displayed value in
increments.
Confirm the length with the
z
Enter key.
In the list, select the material
z
of the pipe section using the
Arrow keys. You can also use
the direct option to enter the
sound velocity manually.
Pay attention to the following:
z
The values in the list are ap
-
proximate values and may be
subject to inaccuracies (see
section 5.)
In the displayed list, select the
z
pipe diameter using Arrow keys.
