Bleeding the system
If the appliance has not been used for more than 2-3 days, stale water and some air will
accumulate in the system.
On rare occasions air may have been drawn into the system while frothing milk. In this case,
the next coffee to be brewed will be very strong, as too little water is passing through.
In either case, proceed as follows to bleed the system:
- Fill the tank with clean, cold tap water, observing the Max mark.
- Press the On/Off switch to turn the appliance on. The switch starts flashing.
- Place a suitable container under the frothing nozzle and turn the rotary control anti-
clockwise until water is emitted from the frothing nozzle into the container.
If the unit is already pre-heated, some steam will be dispensed first, before water is
emitted.
- As soon as the container is filled with water, turn the rotary control all the way back
clockwise. The water flow stops. Pour away the collected water. The unit is now ready
for use again.
Cleaning
●
Before cleaning the appliance, ensure it is disconnected from the power supply and has
cooled down completely.
●
Do not immerse the appliance, power cord or plug in water or other liquids.
●
Do not use abrasives or harsh cleaning solutions.
Housing
The exterior housing may be wiped with a soft, slightly damp cloth.
Drip tray and drainer
The drip tray and drainer may be cleaned with water or in a dishwasher.
- clean the drip tray and drainer and wipe them properly dry afterwards.
- assemble both parts and replace the drip-tray assembly back into the unit, ensuring that
it is pushed back all the way. Double-check that it is properly and securely fitted.
Water tank
The water tank should be cleaned once a week.
- remove the water tank by lifting it straight out.
- clean the tank under tap water and wipe thoroughly dry. The tank is
not
dishwasher-
proof.
- replace the tank.
Capsule holder
The capsule holder consists of two parts and must be disassembled to
ensure proper cleaning.
- Turn the upper part of the capsule-holder anti-clockwise all the way
and then lift it off.
- Both parts may be cleaned with warm water using a mild detergent.
Rinse thoroughly with clean water and wipe thoroughly dry. The
capsule-holder is
not
dishwasher-proof.
- Fit the upper part of the capsule-holder into the lower part and turn
clockwise as far as it will go, making sure the two parts are securely
connected.
31
