![Sesamo smart PRO Скачать руководство пользователя страница 42](http://html1.mh-extra.com/html/sesamo/smart-pro/smart-pro_operating-instructions-manual_1247168042.webp)
42
SESAMO
SMARTPRO
CONTACT
FUNCTION
DESCRIPTION
1-2
--
Power supply
15Vdc
–
12W Max*
Power supply output for sensor or other opening devices
3-8
NA Auxiliary input 2
Input contact with configurable functions as indicated in the
parameters chart (see pag.56 parameter 16)
4-8
NA Auxiliary input 1
Input contact with configurable functions as indicated in the
parameters chart (see pag.56 parameter 15)
5-6
NA Auxiliary output A/B
Auxiliary output configurable as follows:
7-8
NC Not Used
Not Used
8-9
NC Safe Open
Contact safety sensor in opening. If safety sensor installed in
the opening door wing and wired to control board on
terminal (Safe Open) detects and obstacle during opening, it
stops immediately the movement of the door. If the
detection stops, the door starts the movement in opening
and then closed in normal speed.
Sensor’s detections in
closing does not influence the movement and door keep
going on its movement. In case of installation with a door
opening close to a wall (for example in a corridor) it is
mandatory to set a value (% of the full opening) where
sensor does not detect the wall as an obstacle. This value can
be set modifying parameter 20 (see paragraph
“
Managing
parameters function-
display”).
10-11
--
Power supply
15Vdc
–
12W Max*
Power supply output for sensor or other opening devices
12-13
NC Safe Close
Contact safety sensor in closing. If safety sensor installed in
the closing side of the door and wired to control board on
terminal (Safe Close) detect an obstacle in closing, it stops
and reverse immediately the movement of the door, going
to full opening at standard speed and consequently in closing
at normal speed.
Sensor’s detections
in opening does not
influence the movement and door continue to move.
13-14
NC Test
Test safety sensor.
15-16
NC Key
Key command. Lock signal. Closing devices can be connected
(electronic key, key selector switch, card reader, etc)
If the signal is open, control board gives instruction to close
doors. (starting from any position). Until the signal is closed,
Содержание smart PRO
Страница 1: ...1 SESAMO SMARTPRO AUTOMATISM FOR SWING DOORS OPERATING INSTRUCTIONS ENGLISH...
Страница 33: ...33 SESAMO SMARTPRO Arm in closed position...
Страница 38: ...38 SESAMO SMARTPRO 4 Refit switching and control board insert cable connector in the dedicated electric clamp...
Страница 68: ...68 SESAMO SMARTPRO 28 WIRING AND USE OF INTERLOCK With priority Without priority...