Sepura SBR8000, Инструкция по установке и эксплуатации

Страница: 12 / 15

10
DMR Repeater SBR8000, SCR8000, SER8000
Attaching the desk mount feet
If the repeater is installed onto a desk or bench, the four screw
type desk mount feet, supplied with the product, should be
attached.
Using a soft cloth or rubber mat to protect the external surfaces,
place the repeater with the underside facing upwards, onto a
flat surface.
Secure the feet into position using the screws supplied.
Connections
All connectors are located on the back panel of the repeater.
Ensure that the cables are routed so that they are kept well clear
of the antenna cable.
Route cables carefully to eliminate the possibility of damage by
sharp edges. Ensure all cabling is secured and routed to avoid
the risk of a trip hazard.
AC power supply
Connect AC power supply to the 110/240V AC power input
connector.
Connect the repeater grounding point to an appropriate
earthing point.
DC power supply
The Repeater Battery Backup cable (optional) is required to
connect the repeater to the DC power source.
Connect the repeater grounding point to an appropriate
earthing point. Connect the cable to the DC connector on the
repeater. Connect the red wire to the positive terminal on the
DC power source. Connect the black wire to the negative
terminal on the DC power source.
If the power cable needs to be shortened, it must be shortened
from the DC power source connection end. A fuse must be fitted
to the positive line (red wire) when the cable has been
shortened. A new fuse holder must be fitted (not supplied)
because the existing fuse holder cannot be reused. The fuse must
be positioned close to the DC power source positive terminal.