Sennheiser evolution wireless 300 IEM G3, Инструкция по эксплуатации

Страница: 30 / 38

Cleaning the devices
28
Using freely selectable frequencies
You can also freely select the frequencies and store these frequencies in the frequency banks
“
U1 ” to “ U6 ”.
If you want to use the frequency banks “ U1 ” to “ U6 ”:
왘
Make sure to use transmitters and receivers from the same frequency range (see page 4
and the type plates of the devices).
왘
Set each transmitter to the same frequency bank (“ U1 ” to “ U6 ”).
왘
On one of the transmitters, select a channel within this frequency bank (see page 24).
왘
Assign this channel one of the calculated transmission frequencies (see page 24).
Either:
왘
Then carry out the Sync function for each transmitter/receiver pair (see table on page 21,
right-hand column).
This establishes a transmission link between each transmitter/receiver pair.
Or:
왘
Manually set the receiver to the same frequency bank, channel and frequency that you set
on the transmitter (see page 24).
Cleaning the devices
SR 300 IEM G3 transmitter
왘
Before cleaning, disconnect the device from the mains.
왘
Use a slightly damp cloth to clean the device from time to time. Do not use any solvents
or cleansing agents.
EK 300 IEM G3 diversity receiver
왘
Use a slightly damp cloth to clean the device from time to time. Do not use any solvents
or cleansing agents.
To ensure that the desired frequencies are intermodulation-free:
왘
Contact your Sennheiser partner (see www.sennheiser.com).
CAUTION! Liquids can damage the electronics of the devices!
Liquids entering the housing of the devices can cause a short-circuit and damage the
electronics.
왘
Keep all liquids away from the devices.